Visual Intercom Specific Installation Process
With the rapid development of science and technology, electronic products emerge in endlessly, especially various video intercom systems are becoming more and more popular, which brings greater convenience to the development of enterprises and people's lives. Introduce the installation process of building intercom to those in need.
Before installing the equipment, it is necessary to conduct a comprehensive inspection of all the lines of the video intercom system to determine whether there are disconnections and short circuits. After confirming that the wiring of the entire system is not faulty, you can start to install the video intercom equipment.
The installation position and height should meet the design requirements. When there is no design requirement, the video walkie-talkie should be installed in a relatively hidden or safe place, with the bottom edge 1.4m above the ground. When installing, the cabinet should be level and not inclined. When the video intercom is concealed, the box should be close to the visible surface. It is strictly forbidden to weld the box and the embedded pipe together by electric or gas welding. The power box of the video intercom device is usually set on the wall inside the anti-theft iron door, not too far from the electronic control lock, generally within 8m. Do not place or place the power supply when it is working normally. Installation of the entrance body. The entrance body is usually embedded in the buried box of the anti-theft door and the wall body. The distance from the bottom of the host should not be higher than 1.5m. The operation panel should be facing tourists and easy to operate. The installation should be firm and reliable, and ensure the effective viewing angle range of the camera lens. When installing video intercom host equipment outdoor intercom door host. In order to prevent rainwater from entering between the host and the wall, glass glue should be used to block the gap. The installation height of the host is 1.5m from the camera ground. The installation height of the indoor unit is 1.3-1.5m from the ground. The installation should be firm and reliable, and the straight line should not be inclined. The host of the networked (visual) intercom system should be installed in the monitoring center.
Before wiring the video intercom device, check again the insulation between the laid cables and the cable to the ground. After passing the test, you can terminate it according to the wiring diagram of the device. When the video intercom is connected to the cable with a dedicated connector, the crimp connection is firm and reliable, and the wiring ends are numbered with drawings. Finally, the professional video intercom system installation organization pointed out that before powering on and debugging, the video intercom host equipment should be checked. After all installations are completed, you must fully check whether the wiring of each part is correct. In particular, check whether the power cord is connected incorrectly, and whether there is a short circuit between the positive and negative terminals. All in all, you must be careful when installing the building intercom host system. Only when the building intercom system is installed correctly can you provide you with considerate and convenient services.
